Earthquaker Devices - Park Colby Sound Germanium Fuzz
Das Park Fuzz heißt in Europa Colby Fuzz....
The Park Amplification company, originally started by Jim Marshall himself, has almost as much history as the actual Marshall name. As the story goes, Jim Marshall entered a distribution deal for his amp line in 1965, but the terms of the deal were vague enough such that Marshall could build amps on the side, just not under his own name. Thus, Park was born, and the amps produced under that name were slight variations on Marshall circuits until the company dissolved in 1982.
Among the line of amps, a few pedals were also produced. Most of them were wahs or variations thereof, but one pedal stuck out: The Park Fuzz Sound.
The original pedal (we had one) featured unlabeled TO-1 package transistors, so one would think that the circuit left us with Jim Marshall. However, the good folks at Earthquaker Devices, in collaboration with the newly-resurrected Park Amplification, have faithfully recreated the Park Fuzz Sound so that a new generation may enjoy it.
While the original deployed the aforementioned mystery cans, the new Park Fuzz Sound uses a different set of NOS germanium transistors, hand-selected for a tonal match. Indeed, when A/B’d with the original unit, the sounds were strikingly similar. In fact, the staff at PGS was split right down the middle as to which was which. What’s more, when doing the test, we had to set the new Park Fuzz Sound’s Fuzz control at about half, whereas the original was dimed. The reissue has way more range in the Fuzz dial than the original.
Another bugaboo of original fuzz pedals is the powering situation; in the case of the original Park, it’s powered by a battery only but changing it out required using a lever to pry open the lid. While that’s a hassle, using batteries is kind of a hassle in and of itself. However, this and many older fuzz pedals are positive-ground; the common workaround is reversing the lugs on the power jack internally, but this configuration means that the pedal cannot be daisy-chained. The new Park Fuzz Sound doesn’t phone it in, offering a chip inside that corrects the voltage problem for complete rig integration.
The new Park Fuzz Sound is hand-made, one at a time in exotic Akron, Ohio. The pedal is wire for true bypass and accepts a standard 9v center-negative Boss-style power adapter. The current draw is low, so it’s ready for your isolated power supplies.
Measures
4 5/8″ x 2 1/2″ x 2.25″ with knobs
Power
This device can be powered by a standard 9 volt DC power supply intended for musical instruments with a negative center 2.1mm barrel or a 9v battery. Even though this pedal is a germanium fuzz, it will play nice on a daisy chain due to it’s internal voltage regulation. Powersupply not included
Controls
Volume: This is the level control, louder to the right, quieter to the left.
Treble/Bass: This is the tone control, thicker tones to the right, brighter to the left.
Fuzz: This is the gain control, more fuzz to the right, less to the left.
| Marke | EarthQuaker Devices |
|---|
English Version below.
Allgemeine Sicherheitshinweise
• Bevor Sie das Gerät in Betrieb nehmen drehen Sie bitte alle Regler auf Minimum bzw. auf „Null“.
• Lesen Sie die Bedienungsanleitung sorgfältig durch, bevor Sie das Gerät in Betrieb nehmen.
• Bewahren Sie die Bedienungsanleitung für zukünftige Referenz auf.
•Verwenden Sie das Gerät nur für den vorgesehenen Zweck.
• Halten Sie das Gerät von Wasser, Feuchtigkeit und extremen Temperaturen fern.
• Bewahren Sie das Gerät außerhalb der Reichweite von Kindern auf.
Elektrische Sicherheit
• Vergewissern Sie sich, dass die Netzspannung mit den Angaben auf dem Gerät übereinstimmt.
•Verwenden Sie nur das mitgelieferte Netzteil oder ein gleichwertiges, von einem Fachmann empfohlenes Netzteil.
• Ziehen Sie den Netzstecker, wenn das Gerät längere Zeit nicht benutzt wird.
• Schützen Sie das Netzkabel vor Beschädigungen.
• Verwenden Sie das Gerät nicht, wenn das Netzkabel beschädigt ist.
• Vermeiden Sie den Kontakt des Geräts mit Wasser oder anderen Flüssigkeiten, um das Risiko eines elektrischen Schlages zu minimieren.
Hinweise zur Reparatur
• Reparaturen dürfen nur von qualifiziertem Fachpersonal durchgeführt werden.
• Versuchen Sie nicht, das Gerät selbst zu öffnen oder zu reparieren, da dies zu schweren Verletzungen oder Schäden am Gerät führen kann.
• Bei Funktionsstörungen oder Defekten wenden Sie sich an einen autorisierten Service-Techniker oder an uns. info@effekt-boutique.de
Warnhinweise
• Öffnen Sie das Gerät nicht. Es enthält keine vom Benutzer zu wartenden Teile.
• Stellen Sie sicher, dass die Lüftungsschlitze des Geräts nicht blockiert sind, um Überhitzung zu vermeiden.
• Verwenden Sie das Gerät nicht in der Nähe von entflammbaren Materialien oder Flüssigkeiten.
• Ziehen Sie bei Gewitter oder längeren Betriebspausen den Netzstecker, um mögliche Schäden durch Spannungsspitzen zu vermeiden.
• Setzen Sie das Gerät nicht direkter Sonneneinstrahlung oder anderen Wärmequellen aus.
• Essen Sie keinen gelben Schnee
General safety instructions
• Before you start using the device, please turn all controls to minimum or “zero”.
• Read the operating instructions carefully before using the device.
• Save the instruction manual for future reference.
•Use the device only for its intended purpose.
• Keep the device away from water, moisture and extreme temperatures.
• Keep the device out of the reach of children.
Electrical safety
• Make sure that the mains voltage matches the information on the device.
•Use only the included power adapter or an equivalent power adapter recommended by a professional.
• Unplug the device if the device is not going to be used for a long period of time.
• Protect the power cord from damage.
• Do not use the device if the power cord is damaged.
• Avoid contact of the device with water or other liquids to minimize the risk of electric shock.
Repair instructions
• Repairs may only be carried out by qualified specialist personnel.
• Do not attempt to open or repair the device yourself as this may result in serious injury or damage to the device.
• In the event of malfunctions or defects, contact an authorized service technician or us. info@effekt-boutique.de
Warnings
• Do not open the device. It contains no user-serviceable parts.
• Make sure the device's ventilation slots are not blocked to avoid overheating.
• Do not use the device near flammable materials or liquids.
• During thunderstorms or long breaks in operation, pull out the power plug to avoid possible damage caused by voltage peaks.
• Do not expose the device to direct sunlight or other heat sources.
• Don't eat yellow snow
Hersteller / Manufacterer:
EarthQuaker Devices
350 W. Bowery St
44307 Akron, Ohio
Vereinigte Staaten
https://www.earthquakerdevices.com/devices
IT@earthquakerdevices.com
Imported by
Warwick GmbH & Co Music Equipment KG
Gewerbepark 46
08258 Markneukirchen
Deutschland
https://www.warwick.de
info@warwick.de